Step 1.
Separate the VelcroŽ fasteners on the bottom side of the quilt that connect the plaid
cover to the black vinyl bottom sheet. Grasp the VelcroŽ, not the cover to separate. Grasping the
cover will pull the cover away from the VelcroŽ.
|
| |
Step 2.
Continue on all four sides.
|
| |
Step 3.
Remove cover.
|
| |
Step 4.
Remove quilted absorbent pad by grasping and pulling from underneath the vinyl bottom sheet perimeter
folds.
|
| |
Step 5.
Machine wash cover separately, in warm water. Tumble dry low heat.
|
| |
Step 6.
Machine wash quilted pad separately, in warm water. Tumble dry low heat.
|
| |
Step 7.
Wipe the vinyl bottom sheet clean with warm soapy water or other household cleaner. (Note: Use care
to raise the flap around the perimeter and wipe underneath the folds).
|
| |
Step 8.
Reinstall the absorbent pad into the black vinyl bottom sheet. Make sure that the quilted pad is
placed in the center of the black vinyl sheet and tucked evenly around the perimeter.
|
| |
Step 9.
Lay out the plaid cover on top of the black vinyl sheet with inserted absorbent pad after step 8
is completed. Insert one corner of the black vinyl sheet completely into the corner of the plaid
cover. Repeat this step on an adjacent corner then reconnect the VelcroŽ fasteners on the bottom
side of the cover between the two inserted corners to the fasteners on the bottom side of the vinyl
sheet. Repeat these steps down each side of the quilt.
|
| |
Step 10.
Adjust the VelcroŽ fasteners as needed to create even tension across the cover. This will ensure that
your guardian quilt lays flat and neatly on the floor.
|
